Line Follower DIY Kit Compatible With Arduino
₹1,949.90
Tax excluded
A specially designed robot kit for all kind of robotics enthusiasts, starting from small kids to adults at a very economical cost. It comes along with an integrated Uno R3 based Robot control board with integrated motor shield. The boards includes one L293D on board for running DC and Stepper motors with upto 1 Amps of current discharge capability. The board is pre loaded with boot loader and can be programmed with other functionalities aswell such as interfacing sensors, Uart communications, I2C interface and many more. The kit includes 2 x Tcrt5000L sensor module for following black line and IR sensor for obstacle sense. The line follower sensor provides a high signal when a black line is detected and Ir sensor also provides high signal when it sense any obstacle.
Specifications:
ATmega328 microcontroller
32 KB Flash Memory
6 Analog Inputs
16Mhz Clock Speed
4 H-Bridges: L293D chipset provides 0.6A per bridge (1.2A peak) with thermal shutdown protection, internal kickback protection diodes. Can run motors on 4.5VDC to 25VDC
Two 5V hobby servos can be connected
Up to 4 bi-directional DC motors with individual 8-bit speed selection
Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping
Pull down resistors keep motors disabled during power-up
Package Includes:
1 x Programmable Uno R3 Board Compatible with Arduino
1 x Robot Chassis
2 x TCRT5000L line tracking module
1 x IR Object Sensor
1 x Castor small
Screw, nut and Spacers
Cd including sample codes and software
10 Items
Specific References
16 other products in the category
Raspberry Pi T-Cobbler Plus...
E18-D80NK Adjustable IR...
Specifications and Features of E18-D80NK Adjustable IR Sensor Proximity Switch 3-80cm...
₹155.00
40 Pin Jumper Wires
These are Jump / Jumper wire used in connecting various header pin of any development...
₹80.00
A specially designed robot kit for all kind of robotics enthusiasts, starting from small kids to adults at a very economical cost. It comes along with an integrated Uno R3 based Robot control board with integrated motor shield. The boards includes one L293D on board for running DC and Stepper motors with upto 1 Amps of current discharge capability. The board is pre loaded with boot loader and can be programmed with other functionalities aswell such as interfacing sensors, Uart communications, I2C interface and many more. The kit includes 2 x Tcrt5000L sensor module for following black line and IR sensor for obstacle sense. The line follower sensor provides a high signal when a black line is detected and Ir sensor also provides high signal when it sense any obstacle.